California Access M665S User Manual page 125

Problem
The system never goes
into a power saving
mode.
The Wireless LAN/
Bluetooth modules
cannot be detected.
The PC Camera module
cannot be detected.
The Wireless LAN/
Bluetooth/ PC Camera
modules cannot be
configured.
Power Options features are not enabled. Go to the Windows Power Options menu and enable
the features you prefer (see
on page D - 22). Make sure you have enabled Hibernate mode from the control panel.
The modules are off. Check the LED indicator
WLAN/Bluetooth module is on or off (see
off, then press the Fn + F11 (WLAN) or Fn + F12 (Bluetooth) key combination(s) in order to
enable the modules (see "Function Keys" on page 1 -
The module is off. Press the Fn + F10 key combination in order to enable the module (see
"Function Keys" on page 1 -
page 7 - 12/"PC Camera Module" on page D -
The driver(s) for the module(s) have not been installed. Make sure you have installed the driver
for the appropriate module (see the instructions for the appropriate module in
Options" on page 7 - 1).
Possible Cause - Solution
"System Power Options" on page 3 - 6/"System Power Options"
and/or function key indicator to see if the
"LED Indicators" on page 1 -
10).
10). Run the BisonCap program (see
40) to view the camera picture.
Problems and Possible Solutions 8 - 11
Troubleshooting
7). If the LED indicator is
"PC Camera Module" on
"Modules &
8