Detailed Function Description; Scan & Scan Mode Setting - Maas AHT-28-V User Manual

DETAILED FUNCTION DESCRIPTIONS
1) Scan & Scan Mode setting (SCAN&SCANS---MENU 1&17)
Functions: under VFO/MR/CH mode, the transceiver allows you to scan the entire
current operating band and memory channels.
st
Enter Menu 1
When you have started scanning, press [
will halt on a signal it encounters, press PTT key to stop scanning; Press MONI key to
stop scanning temporarily; Press [
Scanning operation is basically the same in each of the above modes. Before you begin,
take a moment to select the way in which you would like the scanner to halt on a signal.
Enter Menu 17
Three options for the scan mode are available under VFO mode:
TO: In this mode, the scanner will halt on a signal it encounters, and will hold there for
some time. If you do not take action to disable the scanner within the time period,
the scanner will resume even if the stations are still active.
CO: In this mode, the scanner will halt on a signal it encounters, and will hold there if
the stations are still active. And after the carrier has dropped, the scanner will
resume.
SE: In this mode, the scanner will halt on a signal it encounter, it will not restart
automatically; you must manually re-initiate scanning if you wish to resume.
30
and press [ ] key to start scanning.
th
to set scan mode. Default: TO.
] / [ ] key to change direction. And it
] key again to exit the scanning function.