JVC KD-NX901 Service Manual page 19

3.2.5 Removing the clamper unit
(See Figs. 6 to 10)
• Remove the top cover and the mechanism section.
(1) Remove the clamper2 spring on the bottom of the mecha-
nism section. (See Figs.6.and 10)
(2) Release the part d of the clamper spring from the bending
part of the chassis base assembly. (See Fig.8)
(3) Move the clamper unit in the direction of the arrow and turn.
Release the two joints e and f, then remove the clamper
unit upward. (See Fig.6)
3.2.6 Reattaching the clamper unit
(See Figs. 6 to 10)
(1) Attach the clamper spring to the clamper unit. (See Fig.9)
(2) Move the clamper unit to set the side joints e and f to each
boss of the chassis base assembly. Make sure that part g
is inserted to the notch of the chassis base assembly. (See
Figs.6 and 10)
(3) Move the part d of the clamper spring to the outside of the
bending part of the chassis base assembly. (See Fig.8)
(4) Attach the clamper2 spring to the chassis base assembly.
(See Figs.6 and 7)
Caution:
When reattaching, temporarily hook the end of the clamper
spring as shown in the figure to make the work easy. (See
Fig.9)
Clamper unit
Clamper spring
f
Clamper2 spring
Chassis base assembly
Fig.6
Clamper2 spring
Chassis base assembly
Fig.7
g
e
(No.MA161)1-19