Viking 30'' W Service Notebook page 40

ILLUSTRATION # 1
VESO/VEDO COMPONENT ACCESS
To gain access to the electric and electronic
components:
!
Remove the top trim (A). Two screws at each
corner attaching the top trim to the side trims and
three screws along the bottom of the trim piece.
!
Remove the lower control panel trim (B).
Three screws along the bottom of the trim piece
behind the oven door.
!
Remove the control panel. Four screw at the
top and six screws across the bottom (see
drawing of the control panel). Pull the control
panel carefully forward and tilt down. Being
careful not to disconnect wires attached to the
components on the reverse of the panel.
!
The component panel is now accessible. Pull
the component panel forward to release the
panel from the slide.
!
Lift the component panel up to service the
upper oven self cleaning latch and components
located on the latch mechanism.
!
The bottom trim piece (C) is removed to make
the vertical door adjustment. Remove the two
screws from each corner attaching the bottom
trim to the side trim pieces. Remove the three
screws across the top of the trim piece located
beneath the door.
40