Identifying Your Product; Installation - Black & Decker Powerful Solutions NW36XXY Original Instructions Manual

Features
1. On/off switch
2. Dust bowl
Fig. A
3. Crevice tool
4. Wet pick-up accessory
Unpacking

Identifying your product

The model design can be determined
from the suffix codes used in the
catalogue number. The following
catalogue numbers are described in this
manual: NW36XXY H2/NW48XXY H2
The suffix code XX corresponds to the
following designs:
00: stick handle, no accessories supplied
03: loop handle, supplied with crevice
tool and brush tool
60: loop handle, supplied with crevice
tool and wet pick-up accessory
The suffix code Y is used to identify the
range of colour options. The suffix code
Y represented by the letter N is used for
models with an NiMH battery.

Installation

Fitting the charging base to the
wall (fig. C1 & C2)
The charging base can be placed on a
worktop or fitted to the wall to provide a
convenient storage and charging point
for the appliance.
Assembly
Fitting the accessories (fig. A & D)
The appliance is supplied with the
following accessories:
a crevice tool (3) for confined spaces
u
a wet pick-up accessory (4) for wet
u
spills
To fit an accessory, proceed as follows:
Take the accessories from the
u
appliance.
Insert the appropriate accessory into
u
the front of the appliance.
You may refit the other accessory by
clicking it into the accessory holder.
To refit both accessories:
Push the accessories down until they
u
click into place.
Use
The appliance can be charged while
u
placed on a worktop or hung on the
wall using the wall hook provided.
Before first use, the battery must be
u
charged for at least 24 hours.
Leave the appliance connected to the
u
charger whenever it is not in use.
Charging the battery (fig. B)
Make sure that the appliance is
u
switched off. The battery will not be
charged with the on/off switch in the
on position.
Fit the appliance properly on the
u
charger aligning the arrow on the
charger with the split of the
appliance.
Plug in the charger.
u
Switch on at the mains.
u
Leave the appliance to charge for at
u
least 24 hours.
Whilst charging, the charger may
become warm. This is normal and does
not indicate a problem. The appliance
can be left connected to the charger
indefinitely.
Warning! Do not charge the battery at
ambient temperatures below 10 °C or
above 40 °C.
Switching on and off (fig. E)
To switch on, slide the on/off switch
u
(1) forward.
To switch off, slide the on/off switch
u
back.
7