Siemens Service Equipment; Introduction - Siemens C35 series Service Manual

Siemens Service Equipment

U S E R M A N U A L

Introduction

Every LSO repairing Siemens handset must ensure that the quality standards are observed.
Siemens has developed an automatic testing system that will perform all necessary
measurements. This testing system is known as
S i e m e n s M o b i l e S e r v i c e E q u i p m e n t
Using this system vastly simplifies the repair of the phones and will make sure that:
1. All possible faults are detected
2. Set which pass the test will be good enough to return to customer.
Starting from the P35 Series, Siemens will introduce a simpler and faster testing platform for
testing a repaired Siemens mobile phone. The testing platform are either base on R&S CMD
53/55 or CTS55 GSM test set.
There is also test software under development for testing with the Wavetek 4201S and the 4107
GSM test set.
A Level 2.5 service software is also under development for more elaborate testing for the repair
for the P35 series mobile phone.
1
THE LSO WILL HAVE TO PURCHASE THE SYSTEM, CHOOSING BETWEEN
A F U L L Y A U T O M A T I C T E S T P R O C E D U R E I S O N L Y
1
Make sure that your CTS firmware is Version 3.01 or higher. For CMD
55 it must be Version 4.03 and higher. Please check with the Service
Info SB_0500 for the CTS/CMD Hardware Options.
V1.0
THE COMPLETE PACKAGE OR SUB-SET OF
P O S S I B L E I F T H E C O M P L E T E S Y S T E M I S
37
I N S T A L L E D .
Chapter
3
IT.