Advertisement
TRANSPORTING & USING THE AquaTRAM PT:
The AquaTRAM PT has been designed to make transporting and using the lift as
simple as possible. The design makes the lift 100% ADA compliant by providing two
separate operating modes; one for transporting the lift and one for using it.
WARNING: TO AVOID PERSONAL INJURY AND/OR EQUIPMENT DAMAGE
DO NOT ATTEMPT TO USE THE LIFT WHILE IN THE TRANSPORT MODE!
MODES OF OPERATION:
1] TRANSPORT MODE: In this mode the lift is on top of the portable cart and the
brake-foot is raised, allowing the lift to roll and turn freely. The safety flag and
fiberglass pole also inhibit use of the lift while in this position.
2] OPERATION MODE: In this mode the lift is on the deck surface and the
brake-foot is lowered, keeping the cart and lift stable and stationary. To place
the lift in this position, follow the instructions below.
TRANSPORT INSTRUCTIONS:
a.
Roll the AquaTRAM PT to desired position on the deck. Stand behind the
lift and tilt it back and down as shown below. Tilt the lift to almost
horizontal so that the pins follow the guide frames on either side (base
rolls on upper wheels).
b.
Slide the lift forward until it comes to the end of the guide frame and the
pins slide into the slots. Make sure that both pins are in the slots.
c.
Pivot the lift forward and down until it rests flat on the deck. Turn the
handle of the brake-foot clockwise until the brake-foot is firmly in contact
with the deck. The lift is now ready to use.
9
Advertisement
