Advertisement
TM
AquaTRAM
LT/PT POOL LIFT OPERATING INSTRUCTIONS:
NOTE:
TIGHTNESS AND FOR WORN PARTS BEFORE
EACH USE. NEVER OPERATE THE LIFT WITH
THE ARMRESTS FLIPPED UP.
LOADING FROM A WHEELCHAIR:
The AquaTRAM LT/PT Pool Lift should always be in
the fully upright position when transferring into the
chair. Before transferring, check to make sure the lift
is operating by making a short test run: move the
chair at least part way in and out of the pool.
The armrest on either side will flip up to allow for
easier lateral transfers. Transfer into the chair and
then lower the flip-up armrest back into its normal
position. Secure the adjustable lap belt around the
waist so that the belt is snug, but not uncomfortably
tight.
AquaTRAM LT/PT
IN FULL UPRIGHT
OPERATING THE AquaTRAM LT/PT:
POSITION
The HANDSET CONTROL is used to raise and
lower the lift during operation. To lower the chair into
the pool, press and hold the ▼ "MOVE DOWN"
button (see diagram to the left). The lift will move
"DOWN" towards the water as long as the ▼ "MOVE
DOWN" button is pressed. To stop moving, simply
release the button. To "MOVE UP" back to the fully
upright position, press and hold the ▲ "MOVE UP"
button. Again, the lift will move only as long as the
button is pressed and held.
When you are sufficiently submerged into the water,
release the ▼ "MOVE DOWN" button. Now remove
the lap belt by grasping the end of the belt that is
protruding above the lap belt and tugging gently. To
create more room in front of the chair, the footrest
may be flipped inwards, under the chair. Exit the
chair by sliding straight forward until you are clear of
the seat and the footrest.
When you are ready to return to the lift, make sure
that the chair is lowered (submerged) sufficiently to
allow you to easily slide into the chair. Next, re-
secure the adjustable lap belt snugly around your
waist. Raise the chair out of the pool by pressing
and holding the ▲ "MOVE UP" button, until the lift is
once again fully upright.
12
CHECK ALL NUTS & BOLTS FOR
Advertisement
