Advertisement
AquaTRAM PT- ASSEMBLY INSTRUCTIONS
1. Begin by placing the parts from the previous page at or near to the desired
poolside location.
2. Stack 10 supplied weight plates on the portable platform. To ensure
proper alignment stack 3 to 4 plates, check alignment by temporarily
putting the cover on, remove the cover and then stack 3 to 4 more plates.
Repeat until all 10 weight plates are on the platform and properly aligned.
3. Attach the weight stack cover assembly over the weight stack using the
supplied ¼" NYLOCK NUTS and ¼" FLAT WASHERS. NOTE: Be sure
to use silicone to seal the flange before bolting together.
4. Plug the ACTUATOR CABLE into the 24V CONTROL/BATTERY (see
next page) and attach it to the lift with the supplied WING BOLTS as
shown below. Make sure the actuator cable's plug is fully inserted and
seated, or else the lift will not function (see next page).
6
Advertisement
