Titan SF26S6 Safety And Operating Manual page 9

OPERATION INSTRUCTIONS
Familiarize yourself with the rotary hammer
before use.
Warning:Make sure the hammer is
isolated from the mains supply before
fitting accessories. Before undertaking any
maintenance or operations on the rotary
hammer isolate the plug from the 13 amp
socket.
1. FITTING THE AUXILIARY HANDLE
Attach the handle as shown in Fig2 depending on
being left handed or right handed.
To ensure the handle does not slip forward locate
the "lugs" on top of handle into the grooves at
the front end of SDS drill.
2. FITTING SDS TOOLS OR CHUCK
The hammer is equipped with an SDS-plus
attachment system. The chuck/SDS tools have
slots in the shank. These locate with tabs in the
rotary hammer. Hold the rotary hammer with
one hand facing away from you. See Fig3.Grip
and pull back the fastening sleeve and insert the
chuck/SDS tool.Push inwards until a resistance is
felt. It may be necessary to spin the chuck/SDS
tool until the shaft drops completely into place.
Once you are satisfied it has seated release the
black fastening sleeve.This should lock the chuck
into position.
3.REMOVE SDS TOOL OR CHUCK
Pull back fastening sleeve, hold and remove tool/
chuck. See Fig3.
Note: The SDS tools or chuck will be gripped
firmly by its shank and will not be able to be
removed.
See Fig3. If the chuck/SDS tool is not located
repeat the installation operation again.
4.OPERATING THE SAFETY ON/OFF SWITCH
Your switch is locked off to prevent accidental
starting. Depress switch lock button then on/off
switch and release lock button (see Fig4). Your
switch is now on, to switch off just release the
on/off switch.
5.VARIABLE SPEED SWITCH
7kg SDS PLUS ROTARY HAMMER
Grooves
Lugs
Tighten
Fig 2
Fig 3
Fig 4
Fig 5
SF26S6
loosen