Titan SF26S6 Safety And Operating Manual page 5

-Work with approved safety equipment, such as those dust masks that are specially
designed to filter microscopic particles.
ADDITIONAL SAFETY RULES FOR YOUR SDS HAMMER
This is a powerful hammer. Caution needs to be observed when operating.
1.If the supply cord is damaged have it replaced by a qualified person.
2.Always wear a dust mask.
3.Dress in suitable overalls.
4.Safety boots are recommended at all times especially when using the chisel action.
5.Proper safety gloves are also recommended.
6.When using chisel a dust mask is necessary because of the dust created by the
action.
7.Wear ear protectors. Exposure to noise can cause hearing less.
8.This heavy duty high torque machine should not be used, while standing on a
ladder.
9.Watch out for the initial torque reaction of the drill, especially if the drill or chisel bit
becomes lodged in masonry.
10.Do not use damaged or worn drills.
11.Do not run the machine with any part of the casing missing or damaged.
12.Check walls for hidden electric cable, gas and electric pipe before you start any
drilling task.
13.Chisel bits and drill bits may be flung out of the machine accidentally and cause
serious injury.
14.Before starting to work, always check that the chisel or drill bit is properly locked
in the chuck.
15.Vibrations can injure the hand-arm system. Keep exposure to vibrations as short
as possible.
16.When carrying out work, always hold the drill with both hands and ensure that you
have a stable standing position.
17. Lubricating the gear box.The gear box must be lubricated after approximately 5
hours of use to ensure it works efficiently.A small container of grease is supplied with
the drill.Go to section "Maintenance" for the details.
18. Always use the appropriate safety equipment that is required for the product. e.g.
Goggles / Safety Spectacles, Ear defenders (essential with tools with a noise rating of
over 85dB(A), Gloves and face masks. In all cases ensure that the safety equipment is
in good condition.
19. Ensure that if a side handle or stabilising handle is provided with the power tool
then these are adjusted into a comfortable position and that both handles are used to
securely grip the power tool when in use.
Double insulation:
The tool is double insulated.This means that all the external metal parts are electrically
insulated from the mains power supply. This is done by placing insulation barriers
between the electrical and mechanical components making it unnecessary for the tool
to be earthed.
7kg SDS PLUS ROTARY HAMMER SF26S6