Changing The Position Or Appearance Of The Print - Ice Zodiac Plus Operator's Manual

Zodiac Plus Operator Manual

Changing the Position or Appearance of the Print

The following features can be changed and applied to modify the
quality or position of the print image:
• Print position
• Print orientation
• Darkness of the print image
• Print delay (intermittent mode applications only)
• Print speed (intermittent mode applications only)
• Printhead print position (continuous mode applications only)
• Interleaved printing
The print settings can be viewed and changed through the printhead
setup page by touching the Tools, Setup and Printhead buttons.
Figure 4-12 shows the printhead setup page for printers that have been
installed to work on an intermittent motion packaging machine (prints
only when the target material is stationary).
Figure 4-12: Printhead Setup Page for Intermittent Motion Applications
Figure 4-13 on page 4-15 shows the printhead setup page for printers
that have been installed to work on a continuous motion packaging
machine (prints while the target material is moving).
4-14 Changing the Position or Appearance of the Print
Rev AA