Installing The 7100 Map - Mitel 7100 Installation Manual

For Ethernet-connected systems
Mitel Networks system 1
Mitel Networks system 2
Mitel Networks system 3
Mitel Networks system 4
Mitel Networks system 5
For Serially connected systems
Mitel Networks system 1
•
Port usage
•
Speed
•
Data Bits
•
Parity
•
Handshake
Mitel Networks system 2
• Port Usage
• Speed
• Data Bits
• Parity
• Handshake

Installing the 7100 MAP

To install the 7100 MAP
1. Unpack the 7100 MAP.
2. Locate the 7100 MAP within 1.3 meters (4 feet) of a power source.
3. Place the 7100 MAP on a desk, or install it in a 19-inch rack, using the supplied
mounting brackets. The mounting brackets fasten to the sides of the rack.
4. Connect the cables. Refer to Figure 2 for E/M connection or to Figure 3 for E/S/M
connection.
Table 1 Installation Requirements (continued)
- 5 -
IP Address
(obtain from customer)
Port Settings
(obtain from customer)
Note: The 7100 MAP
default port settings will
work with most serial
devices, but specific cus-
tomer settings should be
verified and applied.
Installation Guide
Port
(Accept the default
(ALL) for Mitel Net-
works systems)
ALL
ALL
ALL
ALL
ALL
Port
(obtain from customer)
Note: The port number is
either 4001 or 4002.