Accessing The 7100 Map Admin Interface - Mitel 7100 Installation Manual

™
Connect the dedicated incoming line to the "Modem 1" port.
š
Plug the RJ-45 connector on the CAT 5 patch cable into the "Ethernet 1" port.
Connect the other end of the cable to the LAN switch.
›
Connect the supplied RS-232 serial cable to the "COMMs" port on the 7100
MAP. Connect the other end to a serial port on a vt100 maintenance terminal
or a PC that has a vt100-type emulation application.
œ
Connect the RS-232 serial ports to the SX-2000 or SX-200 PBX maintenance
ports.

Plug the power cord into the "Power" receptacle on the rear panel. Plug the
other end of the power cable into a power source.
Figure 3

Accessing the 7100 MAP admin interface

You can access the 7100 MAP admin interface locally—or remotely with access
permission from the customer—using a terminal emulator such as Telnet
(local/remote) or HyperTerminal (local only).
Note: You can use Telnet with the 7100 MAP E/M, E/M/S, and E/M/S/U; however,
HyperTerminal requires a serial connection and can, therefore, only be used with the
E/M/S variants.
Connecting the cables to a 7100 MAP E/M/S or E/M/S/U
- 7 -
Installation Guide