Table of Contents
Advertisement
7100 MAP
5. Proceed to "Accessing the 7100 MAP admin interface" (p. 7)..
™
Connect the dedicated incoming line to the "Modem 1" port.
š
Plug the RJ-45 connector on the CAT 5 patch cable into the "Ethernet 1" port.
Connect the other end of the cable to the LAN switch.
›
Plug the power cord into the "Power" receptacle on the rear panel. Plug the
other end of the power cable into a power source.
Figure 2
Connecting the cables to a 7100 MAP E/M
- 6 -
Hide quick links:
Advertisement
Table of Contents
