Fujitsu Eternus Connection Manual page 13

Chapter 3 Setting Up the Server
> 3.2 Setting Up Brocade Fibre Channel Cards
The following procedure shows an example for setting the port speed, topology, and frame data
size.
Procedure
1
2
3
4
5
6
P3AM-4562-01ENZ0 ETERNUS Disk storage systems Server Connection Guide for Oracle Solaris
Check the "port_id" of the target port.
# bcu port --list
Port# Type PWWN/MAC
1/0 fc 10:00:00:05:1e:e7:45:7b
1/1 fc 10:00:00:05:1e:e7:45:7c
Check the port ID
The port ID checked here is used to set the port speed, topology, and frame data size.
Set the port speed to "8G".
# bcu port --speed 1/0 8
Setting will be enforced after port --disable and -enable
Set the topology to "p2p".
# bcu port --topology 1/0 p2p
Setting will be enforced after port --disable and --enable
Set the frame data size to "2048".
# bcu port --dfsize 1/0 2048
Setting will be enforced after port --disable and -enable
Execute the "port disable|enable" command to apply the port speed, topology,
and frame data size settings.
# bcu port --disable 1/0
port disabled
# bcu port --enable 1/0
port enabled
Check the port speed, topology, and frame data size that have been set.
• Port speed confirmation
# bcu port --speed 1/0
Current port speed is:
Configured port speed is:
• Topology confirmation
# bcu port --topology 1/0
Current topology is:
Configured topology is:
FC Addr/ Media
Eth dev
010400 sw
010500 sw
8G
8G
P2P
P2P
13
State Spd
Linkup 8G
Linkup 8G
Copyright 2010 FUJITSU LIMITED