KitchenAid W10379133A Installation Manual page 17

Door Panels for Dispenser Models
The freezer panel should not weigh more than 40 lbs (18.1 kg).
The refrigerator panel should not weigh more than 50 lbs (23 kg).
A
"
(1.27 cm)
Freezer
" thick
Door
plywood
(Dispenser)
14 "
10 "
(36.2 cm)
(27.6 cm)
Dispenser
cutout is
centered
left-to-right
33 "
(85.7 cm)
3 "
(8.3 cm)
"
"
(1.1 cm)
(1.27 cm)
Model A
36 14 " (36.2 cm)
42 16 " (42.6 cm)
48 19 " (48.9 cm)
NOTES:
Dispenser cutout is centered left-to-right.
If the standard handle is used, the handle side offset of
both panels should be 3 " (8.25 cm) to all for finger
clearance.
If an extended handle is used, the handle side offset of
both panels should be
refrigerator location allows the doors with extended
handles to open to 90 degrees. See "Door Swing
Dimensions."
The dashed lines in the illustration represent the location
and offsets of raised wood panel.
B
(1.27 cm)
Refrigerator
Door
70 "
(178.9 cm)
3 "
(8.3 cm)
Location and offsets
of raised wood panel
(1.27 cm)
B
19 " (48.9 cm)
22 " (57.8 cm)
26 " (66.7 cm)
" (1.1 cm). Make sure the
Dispenser Frame (Classic series dispenser models)
The dispenser frame attaches to the panel with 4 screws.
To remove the dispenser frame:
1. Remove the four screws attaching the frame.
2. Pull the dispenser frame from the decorative panel.
3. To replace the frame, hold the frame to the panel and replace
"
the screws.
"
(1.1 cm)
" thick
plywood
A
"
The dispenser frame overlaps the dispenser cutout by
(0.78 cm) on each side and
A. Dispenser frame
" (1.27 cm) on the top and bottom.
A
A. " (1.27 cm) Overlap
"
A
17