Download  Print this page

Install Overlay Series Custom Panels - KitchenAid W10379133A Installation Manual

Side by side built-in refrigerator.
Hide thumbs


5. Replace the door handles. Install the top screw on each
handle first. Be sure that the top of both door handles are
6. If the door handles are not aligned, loosen all handle screws
and adjust door handles up or down. Tighten the screws.
7. Check refrigerator level and adjustment. Adjust if needed.
Top Grille Panel
1. Grasp both ends of the top grille.
2. Push straight up, then pull straight out. Place the top grille
panel-side down on a soft working surface.
A. Top grille
B. Cabinet side trim
3. Remove one end cap by loosening the nuts and sliding off the
end cap.
A. Bottom rail
B. Nuts
4. Slide the backer panel into the top grille channel and reattach
the end cap.
A. Backer panel
5. Replace the top grille in the cabinet side trims and pull the
panel down slightly to lock it into place.
A. Top grille
B. Cabinet side trim
C. End cap
D. Top rail

Install Overlay Series Custom Panels

Install the custom handles prior to installing the panels on the
refrigerator. For more information on KitchenAid custom
handle selection, refer to the KitchenAid Catalog, visit, or call 1-800-442-9991. In Canada,
visit, or call 1-800-807-6777.
Create custom door overlay panels according to the
specifications in the "Overlay Series Custom Panels" section.
KitchenAid is not responsible for the removal or addition of
molding or decorative panels that would not allow access to
the refrigerator for service.
Door Panel Installation
1. Remove all tape and door bracing from the refrigerator and
freezer doors.
2. Open the refrigerator and freezer compartment doors.
3. Remove the handle-side and top trims.
4. Slide the custom panels into the bottom and hinge side trims
on the refrigerator compartment and freezer compartment
doors, making sure that the backer panel fits into the hinge
side trims.
A. Trims
A. Panels


Table of Contents

   Related Manuals for KitchenAid W10379133A

Comments to this Manuals

Symbols: 0
Latest comments: