Table of Contents
Advertisement
installation & preparation
THE TRIGGER GUN SHOULD ALWAYS BE LOCKED IN THE OFF
POSITION WHEN NOT IN USE!
4. Follow the incoming water requirements listed below:
a. Water pressure must be a minimum of 20 pounds per square
Inch (PSI) and a maximum of 125 PSI. (A typical outdoor faucet will
generally supply this PSI if turned completely "ON".)
b. Incoming GPM must be approximately one gallon more than the
outgoing GPM stated on the pressure washer nameplate. (You can
check GPM by timing how long it takes to fill a 5 gallon container.)
c. Incoming water temperature must not exceed 125°F. Excessive
pump damage may result if the water temperature exceeds this
acceptable level.
5. Never allow the unit to operate without the incoming water line
TALLATION & PREPARATION
attached and the water supply is completely turned on.
g water requirements listed below:
must be a minimum of 20 pounds per square inch (PSI)
m of 125 PSI. (A typical outdoor faucet will generally
if turned completely "ON".)
must be approximately one gallon more than the outgoing
the pressure washer nameplate. (You can check GPM
ong it takes to fill a 5 gallon container.)
WATER INLET STRAINER
temperature must not exceed 125°F. Excessive pump
esult if the water temperature exceeds this acceptable
to operate without the incoming water line attached and
completely turned on.
een preset at the factory.
UNLOADER
LVE:
The unloader has been preset at the factory.
temperature does not exceed acceptable levels, never
washer to operate in the bypass mode (with the unit
ger closed) for more than three minutes.
THERMAL RELIEF VALVE
e has been added to this unit to protect the pump. This
release water if the water temperature in the pump has
This will allow fresh, cool water to enter the system,
To ensure the water temperature does not exceed acceptable levels,
g premature failure of pump packings.
never allow the pressure washer to operate in the bypass mode (with the
unit running and the trigger closed) for more than three minutes.
ION PROCEDURES:
perform the following procedures:
A "thermal relief valve" has been added to this unit to protect the pump.
al cords for cuts. If a cut is found, DO NOT TOUCH OR
ace cord before starting unit.
It may begin to open and release water if the water temperature in the
n the pump.
pump has exceeded 140° F. This will allow fresh, cool water to enter the
let strainer. Clean or replace if necessary. See "Water
system.
nections to ensure they are securely tightened.
water leaks, oil leaks and fuel leaks. If a fuel leak is
ART UNIT! See "Risk of Explosion or Fire", pg. 5. Be
ed parts are replaced and that the mechanical problems
to operation of the unit. If you require service, contact
ure hoses for kinking, cuts and leaks. If a cut or leak
USE HOSE! Replace hose before starting unit. See
Severe Cutting Injury", pg. 6. Be sure that all damaged
and that the mechanical problems are corrected prior to
t. If you require service, contact Customer Service.
WARNING
WATER INLET STRAINER
17
Advertisement
Table of Contents
