Table of Contents
Advertisement
15°
NOZZLE CONNECTION
1. Be certain the trigger gun is locked in the "OFF" position.
40°
2. The nozzle assembly should be disconnected from the gun/wand
assembly at this by retracting the locking ring on the quick-connect
fitting to remove the nozzle.
WATER SUPPLy
1. Select a water supply hose which is a quality grade of garden hose
measuring at least 3/4" ID and no longer than 50 feet.
2 Check the water inlet strainer to ensure it is clean and free of any
obstructions. As a strainer becomes obstructed, it restricts proper
flow of water to the pump. This can result in cavitations which will
prematurely cause failure of pump packings.
a. Using a screwdriver, remove the screen from the water inlet.
b. Clean or replace if necessary.
3. Connect the hoses.
a. Connect one end of the water supply hose to the water inlet of the
unit.
b. Connect the other end of the hose to your pressurized water supply.
12
• Do not use a non-pressurized water supply (i.e. from a pond or well)
with this unit.
• When connecting the water inlet to the water supply mains, local
regulations of your water company must be observed. In some areas,
the unit must not be connected directly to the public drinking water
supply. This is to ensure there is no feedback of detergents into the
water supply. (Direct connection is permitted if a back flow preventer
is installed. Check with local authorities for approval.)
• If there is a high mineral content in your water, it is highly recommend-
ed that a water softener and an additional water strainer be added
to the water inlet to help prevent the possibility of excessive scale
buildup inside the heat exchanger coil. Clean both strainers before
starting your pressure washer.
16
QUICK-CONNECT (Q.C.)
installation & preparation
0°
QUICK-CONNECT FITTING
WARNING
RISK OF SEVERE INJURY!
THE TRIGGER GUN SHOULD
ALWAYS BE LOCKED IN THE OFF
POSITION WHEN NOT IN USE!
NOTICE
from equipment, and cleaning lawn mowe
2. The 15° nozzle (YELLOW): This is a chi
be directed at a 45° angle to the surface an
paint, grease and dirt. Uses: Surface prep
and paint chips).
3. The 40° nozzle (WHITE):
This is a wash nozzle. This wide spray patt
over a large area and is recommended for m
aluminum siding, cleaning windows, washi
driveways, and patios.
NOZZLE CONNECTION:
1. Be certain the trigger gun is locked in the "OF
2. The nozzle assembly should be disconnec
at this by retracting the locking ring on the
the nozzle.
WATER SUPPLY:
1. Select a water supply hose which is a quality
at least 3/4" ID and no longer than 50 feet
2
Check the water inlet strainer to ensure it is c
As a strainer becomes obstructed, it restr
pump. This can result in cavitations whic
of pump packings.
a. Using a screwdriver, remove the scree
b. Clean or replace if necessary.
3. Connect the hoses.
a. Connect one end of the water supply h
b. Connect the other end of the hose to y
NOTE 1:
Do not use a non-pressurized wa
well) with this unit.
NOTE 2:
When connecting the water inlet t
regulations of your water compan
areas, the unit must not be connec
water supply. This is to ensure the
into the water supply. (Direct conn
preventer is installed. Check with
NOTE 3:
If there is a high mineral conte
recommended that a water softene
be added to the water inlet to help pr
of excessive scale buildup inside
both strainers before starting your
12
Advertisement
Table of Contents
