Microsoft Exchange - GFI FaxMaker Getting Started Manual

3.1.4 ISP hosted mail server
GFI FaxMaker can be installed in an environment where the mail server is hosted.
Figure 4 - GFI FaxMaker with hosted mail server
P
ROCESS
Client side
Sending faxes/SMS
Received faxes/SMS
3.1.5 Multiple mail servers
In a large network with multiple mail servers that are independent from each other,
configure all mail servers individually to forward faxes from all mail servers to GFI
FaxMaker. Use the same methods described above for each type of mail server. This
enables provision of fax services to users on several mail servers from a single GFI
FaxMaker server.
3.2

Microsoft Exchange

For Microsoft Exchange 2000 or later, install an SMTP connector on the mail server to route
all emails addressed to faxmaker.com, smsmaker.com and fax: to GFI FaxMaker.
»
GFI FaxMaker installed on Microsoft Exchange server: Configured automatically
during installation - no configuration required.
»
GFI FaxMaker NOT installed on Microsoft Exchange server: Configure connector on
Microsoft Exchange server. Run the GFI FaxMaker setup (same one used to install GFI
FaxMaker) on the Microsoft Exchange Hub Transport role server. When choosing the
components to install, disable GFI FaxMaker Fax Server and select Exchange
2000/2003/2007/2010 SMTP connector. In the next screen, specify the IP address or
server name of the GFI FaxMaker server. For more information about setup, refer to
Installation procedure
GFI FaxMaker
D
ESCRIPTION
Users send faxes/SMS using the GFI FaxMaker Client - Fax Message Form to
route directly to GFI FaxMaker server.
NOTE: Users cannot use email client to send faxes/SMS.
GFI FaxMaker clients route faxes/SMS directly to GFI FaxMaker via SMTP.
NOTE: Install the IIS SMTP service on the GFI FaxMaker server.
After determining the users to forward incoming faxes/SMS to, GFI FaxMaker
sends transmission report via SMTP to the hosted mail server.
chapter in this manual.
Pre-installation action: Configure mail server | 11