Compal CH6643E User Manual page 28

Field Descriptions for the Basic Setup Page
Field
NAPT mode
Ethernet port based
bridging
LAN
IP Address
MAC Address
WAN
IP Address
MAC Address
Rebind Time
Remaining
Renew Time
Remaining
WAN Connection Type
When done, click Apply to save your changes.
Description
NAPT is a special case of NAT, where many IP numbers are hidden
behind a number of addresses. In contrast to the original NAT,
however, this does not mean there can be only that number of
connections at a time.
In NAPT mode, an almost arbitrary number of connections are
multiplexed using TCP port information. The number of simultaneous
connections is limited by the number of addresses multiplied by the
number of available TCP ports.
In NAPT mode, When the check box set, indicates network traffic from
which particular Ethernet port will be bridged to HFC interface. When
the checkbox cleared, indicates network traffic from which particular
Ethernet port will be handled by Gateway routing features.
Enter the IP address of the CH6643E on your private LAN.
Media Access Control address — a set of 12 hexadecimal digits
assigned during manufacturing that uniquely identifies the hardware
address of the CH6643E Access Point.
The public WAN IP address of your CH6643E device, which is either
dynamically or statically assigned by your ISP.
Media Access Control address — a set of 12 hexadecimal digits
assigned during manufacturing that uniquely identifies the hardware
address of the CH6643E Access Point.
Describes how long before your DHCP server binding expires. The
WAN lease will automatically rebind itself when it expires.
Describes how long before your Internet connection expires. The WAN
lease will automatically renew itself when it expires.
DHCP or Static IP.
If your ISP uses static IP addressing, select Static IP and enter the
information provided by your ISP for Static IP Address, Static IP Mask,
Default Gateway, Primary DNS, and Secondary DNS.
25