Connecting The Ch6643E - Compal CH6643E User Manual

Wireless gateway series
Table of Contents

Advertisement

Connecting the CH6643E

Before starting, be sure the computer is turned on and the CH6643E power cord is
unplugged.
1. Connect one end of the coaxial cable to the cable outlet or splitter.
2. Connect the other end of the coaxial cable to the Cable connector on the CH6643E.
Hand-tighten the connectors to avoid damaging them.
3. Plug the power cord into the Power port on the CH6643E.
4. Plug the other end of the power cord into an electrical wall outlet.
This automatically powers on the gateway. You do not need to unplug the gateway
when it is not in use. The first time you plug in the CH6643E, allow it 5 to 30 minutes
to find and lock on the appropriate communications channels.
5. Plug the other end of the telephone cord of a single or two-line telephone into the
port on the rear of the CH6643E.
1/2
6. Plug the telephone cord of a single or two-line telephone into the telephone.
7. (optional step) Plug USB memory stick or hard-disk drive into USB port on CH6643E.
8. Connect the Ethernet cable to the Ethernet port on the computer, and connect the
other end of the Ethernet cable to the Ethernet port on the gateway.
9. For a second telephone, plug the telephone wire of a single-line telephone into the
port on the rear of the CH6643E.
TEL 2
10. Check that the LEDs on the front panel cycle through the following sequence:
CH6643E LED Activity During Startup
LED
POWER
RECEIVE
Description
Turns on when AC power is connected to the CH6643E.
Indicates that the power is connected properly.
Flashes while scanning for the downstream receive channel.
TEL
10

Hide quick links:

Advertisement

Table of Contents
loading

Related Products for Compal CH6643E

Table of Contents