Rip Settings - TP-Link TD-W8970 User Manual

TD-W8970
2. Enter the following data:
Destination IP Address: The address of the network or host that you want to assign to a

static route.
Subnet Mask: It determines which portion of an IP Address is the network portion, and

which portion is the host portion.
Gateway: Type in the correct gateway address for the static route.

Interface: Select the Interface from the drop-down list.

Status: Select Enabled or Disabled from the drop-down list.

3. Click Save to save your settings.
To modify or delete an existing entry:
Find the desired entry in the table.
1
Click Edit as desired on the Edit column.
2
Click the Enable/ Disabled Selected button to make selected entries enabled/ disabled.
Click the Delete Selected button to delete selected entries.

4.11.3 RIP Settings

Choose "Route Settings""RIP Settings", you can see the RIP (Routing Information Protocol)
screen which allows you to configure the RIP.

Note:
RIP cannot be configured on the WAN Interface which has NAT enabled (such as PPPoE).
300Mbps Wireless N Gigabit ADSL2+ Modem Router User Guide
Figure 4-59
Figure 4-60
61