Hardware Installation - Ubiquiti airMAX Titanium Sector AM-V2G-Ti Quick Start Manual

Hardware Installation

1. Set the desired beamwidth by adjusting the Beamwidth
Deflectors. Loosen the four hex head screws enough to move
the Beamwidth Deflectors, but do not remove the screws.
2. Carefully move the Beamwidth Deflectors to the desired angle,
as indicated by the screw slots.
Important:
angle.
3. Tighten the four hex head screws.
Both deflectors must be set to the same
Hardware Installation
120˚ Beamwidth
90˚ Beamwidth
60˚ Beamwidth
3