Ubiquiti airMAX Titanium Sector AM-V2G-Ti Quick Start Manual page 11

Hardware Installation
13. The antenna has an electrical downtilt of 4˚. To further adjust
the elevation angle, loosen the four M8x20 Serrated Flange Bolts
on the U Brackets and the two M8 Serrated Flange Nuts on the
upper Pole Clamp. Slide the antenna to the desired tilt. (The
brackets may slide along the pole, depending on the angle of
the elevation tilt.) Tighten all bolts and nuts to approximately
14 N-m (10 lb-ft) or less to avoid deforming the pole.
M8 Serrated
Flange Nut
M8x20 Serrated
Flange Bolt
M8x20 Serrated
Flange Bolt
9