Korg CX-3 Combo Organ Owner's Manual page 36

Parameters
Default DB Select (Default Drawbar Select)
This controls which settings in the DRAWBAR SELECT
section will be active when the power is turned on.
1 . E n t e r G l o b a l m o d e , a n d s e l e c t t h i s p a r a m e t e r .
2 . Press the [WRITE/ENTER] key.
The display will allow you to specify your choice for
the upper DRAWBAR SELECT section.
3 . U s e t h e [ - ] [ + ] k e y s t o s e l e c t t h e p o w e r - o n s e t t i n g f o r
the upper DRAWBAR SELECT secti o n.
PRESET: When the power is turned on, the [Preset
Drawbar] key will be recalled.
1: When the power is turned on, the [Drawbar 1] key
will be recalled.
2: When the power is turned on, the [Drawbar 2] key
will be recalled.
4 . T o s p e c i f y t h e p o w e r - o n s e t t i n g f o r t h e l o w e r D R A W -
B A R S E L E C T s e c t i o n , p r e s s t h e [
5 . U s e t h e [ - ] [ + ] k e y s t o s e l e c t t h e p o w e r - o n s e t t i n g f o r
t h e l o wer DRAWBAR SELECT sect i o n.
6 . Press the [WRITE/ENTER] key.
When the settings have been registered, the display
will indicate DfltDB Set Completed, and will then
indicate Default DB Select.
Exp Pdl Calibration (Expression Pedal Calibration)
If operating the expression pedal connected to the rear
panel EXPRESSION PEDAL jack does not produce the
appropriate result, use the following procedure to adjust
the sensitivity of the expression pedal.
1 . C o n n e c t t h e e x p r e s s i o n p e d a l t o t h e r e a r p a n e l
EXPRESSION PEDAL jack.
2 . S e l e c t t h i s p a r a m e t e r .
3 . Press the [WRITE/ENTER] key.
The display will indicate Set ExpPdl Min Pos.
4 . M o v e t h e e x p r e s s i o n p e d a l t o t h e m i n i m u m p o s i t i o n ,
and press t h e [ W RI T E/ E NTER] key.
The display will indicate Set ExpPdl Max Pos.
5 . M o v e t h e e x p r e s s i o n p e d a l t o t h e m a x i m u m p o s i t i o n ,
and press t h e [ W RI T E/ E NTER] key.
Wheel Brake ON
This simulates the way in which the tone wheel rotation
slows down when the power of a tone wheel organ is
switched on/off.
When you press the [WRITE/ENTER] key, the tone wheel
rotation will gradually slow down and stop. At this time,
the pitch will also fall. Press the [WRITE/ENTER] key
once again, and tone wheel rotation will gradually
resume.
36
[PRESET, 1, 2]
® ] k e y .
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Group 8: DEMO
DEMO Play
Here you can select and play back the demo songs.
For details, refer to "1. Listening to the demo songs"
(p.11).
[1...9]