Copying A Program; Swapping Two Programs - Korg CX-3 Combo Organ Owner's Manual

4. In the upper DRA WBAR SELECT section, hold
down the [DRA WBAR 1] key and press the [DRA W-
BAR PRESET] key .
The Drawbar 1 settings will be copied to the "UPPER"
parameters, and an " " will appear between the
program number and program name.
5. Press the [WRITE/ENTER] key to write the settings
into internal memory .
For details, refer to "Writing a program" (p.20).
The upper DRAWBAR SELECT section can be used
to copy drawbar parameters in EX mode as well.
Create the sound in the upper keyboard, then hold
down the upper [DRAWBAR 1] or [DRAWBAR 2]
key, and press the [DRAWBAR PRESET] key.

Copying a program

This is convenient when you want to create several
variations of a program by making small changes to the
parameter settings.
1. Press the [GLOBAL] key to enter the Global mode.
2. Press the PROGRAM [7] key , and then press the
[®] key once.
The display will indicate Copy Swap Init.
3. Press the [WRITE/ENTER] key .
In the display, "Copy" will blink, and the copy source
and copy destination program numbers will appear at
the right.
4. Press the [ ® ] key once, and the Speaker icon will
appear at the left of the copy-source program
number .
You can play the keyboard to hear the sound of the
program.
5. To change the copy-source, use the [-][+] keys to
specify the source program number
6. To change the copy-destination, press the [
7. Press the [WRITE/ENTER] key .
8. Press the [WRITE/ENTER] key once again.
This operation exchanges two programs. This is conve-
nient when you want to rearrange the order of the
programs.
1. Press the [GLOBAL] key to enter the Global mode.
2. Press the PROGRAM [7] key , and then press the
3. Press the [WRITE/ENTER] key , and then press the
4. Press the [ ® ] key once, and the Speaker icon will
5. If you want to change the swap source, use the
6. If you want to change the swap destination, press
7. Press the [WRITE/ENTER] key .
8. Press the [WRITE/ENTER] key once again.
.
once, and then use the [-][+] keys to specify the
destination program number
The Speaker icon will appear at the left of the copy-
destination program number.
A message will ask you to confirm the copy.
If you decide to cancel, press the [EXIT] key.
When the program has been copied, the display will
indicate Copy Completed.

Swapping two programs

[®] key once.
The display will indicate Copy Swap Init.
[+] key once.
"Swap" will blink in the display. The swap-source and
swap-destination program numbers will be displayed
at the right.
appear at the left of the swap-source program.
You can play the keyboard to hear the sound of the
program.
[-][+] keys to specify the source program number
the [®] key once, and then use the [-][+] keys to
specify the destination program number
A message will ask you to confirm the swap.
If you decide to cancel, press the [EXIT] key.
When the swap is completed, the display will indicate
Swap Completed.
Basic functions
®] key
.
.
.
23