Add An Output Power Distribution Module - Orion Power Systems SCR2 User Manual

6.3.3 Add an Output Power Distribution Module—Optional
To add an optional output distribution module to the RT 10Kva:
1. Remove the four screws securing the blank output distribution cover plate to the rear of theUPS.
The cover is at top left corner in the tower configuration and at the bottom left in the rack
configuration.
2. Set the screws aside to attach output distribution module to UPS.
3. Snap together the electrical connectors on the UPS and on the output distribution.
4. Use the screws removed in Step 2 to attach the output distribution to the rear of the UPS.
Output Distribution
Cover Plate
Hardwire
Terminal
Block
Cover
Screw holes
to attach to UPS
Electrical Connector
snaps to connector
inside UPS
REAR VIEW
RT 10Kva
16
Installation and Configuration
Screw holes
to attach to UPS
Optional Output
Power Distribution
Module