Table of Contents
Advertisement
Mode
In this setting you can adjust the sound to the environment by using the default EQ,
Filter, Limiter etc. Note: this Menu Item is only available when using a FACTORY
PRESET! User Presets are personalized by you for your own purpose, so that further
sound adjustments are not necessary.
The following parameters can be selected as sound characteristics of the Factory
Presets:
1
2
S
YSTEM VOLUME CONTROL ENABLED
1) Default setting – the audio signal is reproduced without changes
2) The high frequencies increase slightly producing more boost in deep-toned rooms
3) The top unit level reduce slightly producing a powerful sound
4) Is the sound reproduced at low level the deep frequencies increase slightly; at a loud
level the deep frequency volume boost reduces slightly again
L
(see 7.2)
IMITER ENABLED
5) The audio signal is repoduced without changes
6) The high frequencies increase slightly producing more boost in deep-toned rooms
7) The top unit level reduce slightly producing a powerful sound
Note: The setting "Bassdynamic" is not available when the Limiter is enabled because the Limiter
and the Boost of the audio signal eliminate each other.
S
TATUS MULTICOLOR
signals different parameters:
LED is off
LED lights up green - there is an input signal
LED lights up yellow - the Limiter is working (see 7.2)
LED lights up red
LED lights up cyan
LED lights up purple - the User Preset could not be loaded from the SD Card;
8
3
4
(see 7.2)
LED
- there is no input signal
- there is a malfunction; the VSS 28 has to be restarted
- the SD Card User Preset was successfully loaded and
saved on the device (see 7.3)
read error due to faulty file (see 7.3)
5
6
7
Advertisement
Table of Contents
