Table of Contents
Advertisement
8. Quickstart
In this part of the Manual you will find an overview on how to do the first steps at the
startup and adjust the necessary settings and its functions. In complying with these
procedures, a safe use of the VSS 28 is guaranteed.
After setting up the PA system and connecting the cables (SD X or a alternative Versio
system; see 6.) and switching on the VSS 28 you should initially check the adjusted
parameters of the Menu Items and change them if necessary. To control the respective
system optimally, the correct preset has to be loaded. Therefore, you should choose and
load your current setup under the Menu Item "Preset". Please follow the instructions of
7.1 for operating the system.
For a defined and optimum signal level the System Volume Control may to turned to 0 dB
(the adjusting slot is in the vertical position) by using a suitable tool (see 7.2). This
adjustment is a recommendation!
If you use an analogue input audio signal for your PA system you can start
immediately!
If you want to use a digital input signal for your audio system you have to switch the Input
of the VSS 28 to "Digital" (LED indicator: "left", "right" and "digital"; see 7.1). In the
Delivery Status, the Inputs of the VSS 28 are switched to analogue.
Note! When you power up the VSS 28 for the first time the Preset 2 "VERSIO SD X" is
loaded! For more information on the Delivery Status see Page 3.
11
Advertisement
Table of Contents
