Power Connections; Turning Soundbar On/Off; Switching Sources - JBL CINEMA SB200 Quick Start Manual

POWER CONNECTIONS

After verifying that all of the source connections have been made properly,
plug the supplied power cord into the soundbar's Power Cord connector,
and plug the other end into an active, unswitched AC outlet. Do NOT plug
this cord into the accessory outlet found on some audio components.
uSINg Your SouNdBAr SYStEM
TURNING THE SOUNDBAR ON AND OFF
Set the soundbar's Power switcn to the "On" position.
Power Switch
Press the Power button on either the soundbar or the remote to turn
the soundbar on. To put the soundbar in the Standby mode, press
either Power button while the soundbar is on.
Power Button
If you do not press the Power button, the soundbar will automatically go
into the Standby mode approximately 10 minutes after the audio signal
ceases. NOTE: If you have put the soundbar into the Standby mode by
pressing the Power button, you must manually turn it on by pressing
the Power button again. If the soundbar has automatically gone into
the Standby mode 10 minutes after the audio signal has ceased, it will
automatically turn itself on when it receives an audio signal at either
input connection.
If you will be away from home for an extended period of time, or if
you will not be using the soundbar for an extended period, set the
soundbar's Power switch to the "Off" position.
Power Cord
(supplied)
To Unswitched
AC Outlet
100-240V ~ 50/60Hz
Power Button
BASS
BLUETOOTH OPERATION
To wirelessly stream audio to the soundbar from a Bluetooth-enabled
device:
1. Confirm that the soundbar is in the Bluetooth pairing mode (the
Bluetooth button LED will be flashing blue). If the LED is not flashing
blue, press and hold the Bluetooth button until its LED begins to
flash blue.
2. Place the device in the pairing mode. Use the device's Bluetooth
pairing menu to pair it with the soundbar. (The soundbar will appear
as "SB200" in the device's menu.) If the device requires a passcode,
use 0000.
3. When the soundbar's Bluetooth button LED illuminates constantly,
it is paired with the device and you can stream audio via Bluetooth
from the device to the soundbar.
To disconnect the Bluetooth device, press and hold the soundbar's
Bluetooth button until the LED begins flashing. To pair the soundbar
with a different Bluetooth-enabled device, repeat Steps 1 – 3 with the
new device.
Notes on Bluetooth operation:
• You can manually switch sources to the paired Bluetooth device by
pressing the soundbar's Bluetooth button.
• If you switch the soundbar to a different source while a paired
Bluetooth device is streaming to the soundbar, the soundbar will
send a Stop command and the Bluetooth device will stop streaming.

SWITCHING SOURCES

Press the soundbar's or remote's Source button to switch between
the devices you connected to the Aux input and Optical input and a
device streaming audio via Bluetooth. When the Aux input is active the
soundbar's Source indicator will illuminate white; when the Optical input
is active the soundbar's Source indicator will illuminate amber.
Source Button
Bluetooth Button
BASS
Source
Button
www.jbl.com
5