Troubleshooting - Insignia NS-P4112 User Manual

NS-P4112_14-1153_MAN_V6_ENG.fm Page 13 Tuesday, October 28, 2014 8:57 AM
Insignia NS-P4112 Portable CD Player
When you press the
automatically and
and your CD player stores the audio in memory to make sure that
playback does not pause or skip. If your player is bumped or vibrated
too much, the memory buffer gets full and
display. If the memory buffer is full, playback may skip or pause. After
the bumping or vibration stops, your player resumes normal playback.

Troubleshooting

Problem
No sound.
A CD is inserted, but
tracks are not
displayed.
Certain sections of a
CD do not play
normally.
button, the anti-shock feature turns on
appears on the display. The CD spins faster
Notes
You should use the anti-shock feature only
when necessary. Using the anti-shock feature
while your CD player is running on battery
power uses additional battery power. To turn
off the anti-shock feature, press the ESP
button.
The anti-shock feature will not correct
playback errors if the CD is scratched or dirty.
Possible cause Solution
Your CD player does Replace the batteries or make
not have power. sure that the optional AC/DC
power cord is plugged into
your CD player and a AC
power outlet.
Playback has not Press the
been started.
The volume is set Increase the volume.
too low.
The CD is inserted Make sure that the CD is
upside down. inserted with the label side up.
The CD is dirty. Clean the CD.
The CD is scratched Use a different CD.
or warped.
Moisture has formed Remove the CD and leave the
inside the CD CD door open for about an
compartment. hour to dry.
The CD is dirty. Clean the CD.
The CD is scratched. Skip over the scratched
sections, or replace the CD.
www.insigniaproducts.com
appears on the
button.
13