Troubleshooting - Insignia NS-ES6113 User Manual

NS-ES6113_09-0084 ENG.fm Page 24 Wednesday, March 11, 2009 10:29 AM

Troubleshooting

Problem
No power
The remote control
does not work
Cannot connect an
®
iPod
Cannot play an iPod
Cannot charge an
iPod ®
CD does not play
No sound from the
speakers
The system does not
respond when buttons
are pressed
Static or noise when
playing the radio
The shelf system
does not recognize a
USB device
24
Insignia NS-ES6113 CD Shelf System with iPod® Dock
Cause/Solution
• Make sure that the AC power adapter is fully inserted
into the AC power outlet.
• The batteries may be dead. Change the batteries.
• The remote control is not aimed at the remote control
sensor on the shelf system. Aim the remote control
directly at the shelf system when you push the buttons.
• Make sure that the dock adapter you selected is
compatible with your iPod
• Make sure that the dock adapter is correctly mounted on
the shelf system.
®
• Make sure that the iPod
connector on your shelf system.
• Make sure that the iPod
to connect it to the shelf system.
• Make sure that the iPod
connector on your shelf system.
• Make sure that the AC adapter is plugged in and firmly
connected to the DC IN port on your shelf system.
• Make sure that the disc is inserted correctly.
• Make sure that the disc is not dirty or defective.
• If moisture or condensation has accumulated inside your
shelf system, let your shelf system warm up for 60
minutes so the liquid evaporates.
• The disc may not be compatible with your shelf system.
• Make sure that the volume level is set correctly.
• Make sure that the sound is not muted.
• Remove and reconnect the AC power plug and switch on
the system again.
• Make sure that the station is tuned correctly and that the
station has a good signal.
• Try another station.
• If you are playing an AM station, rotate the antenna to
improve the reception.
• If you are playing an FM station, extend the antenna wire
to improve the reception.
• Remove and reconnect the USB device in USB mode.
• Make sure that the USB device is firmly connected to the
shelf system.
• Make sure that the shelf system is set to USB mode.
• Make sure that the USB device is not locked by its HOLD
button.
www.insigniaproducts.com
®
.
®
is firmly inserted into the iPod
® is working. Test it before trying
®
is firmly inserted into the iPod
®
®