Maintaining Your Cd Player; Troubleshooting; Specifications - Insignia NS-DA1902 User Manual

NS-DA1902 5-Disc CD Player
• Files should be named using 12 or fewer
letters or numbers, and must incorporate the
"MP3" or "WMA" file extension. For example,
.MP3 or .WMA .
• Use only letters or numbers in file names. If
you use special characters, the file or folder
names may not be displayed correctly on the
on-screen display.
CD-R discs
This CD player is compatible with CD-R discs.
When recording CD-R discs, use the following
guidelines:
• When recording on CD-R discs, use
74-minute (650MB) discs.
• The CD-R disc should be "finalized" in the
computer by using the "single session
format."
• See your own CD/MP3/WMA creation
software for details.
• CD player can play discs containing audio
data, MP3 data, and WMA data.

Maintaining your CD player

Cleaning discs
A defective or dirty disc inserted into the player
can cause sound to drop out during playback.
Handle the disc by holding its inner and outer
edges.
• Do not touch the surface of the unlabeled
side of the disc.
• Do not stick paper or tape on the surface.
• Do not expose the disc to direct sunlight or
excessive heat.
• Clean the disc before playback. Wipe the disc
from the center outward with a cleaning cloth.
• Never use solvents such as benzine or
alcohol to clean the disc.
• Do not use irregular shape discs (such as
heart-shaped or octagonal). They may cause
malfunctions.
Cleaning the CD player
• Make sure you turn the player off and
disconnect the AC power cord before
maintaining the player.
• Wipe the CD player with a dry soft cloth. If the
surfaces are extremely dirty, wipe clean with
a cloth which has been dipped in a weak
soap-and-water solution and wrung out
thoroughly, then wipe with a dry cloth.
• Never use alcohol, benzine, thinner, cleaning
fluid, or other chemicals.
• Do not use compressed air to remove dust.
Caution Before transporting the CD player, remove
discs from the disc tray.

Troubleshooting

Before calling for service, check the following:
Problem
No power
No sound
Severe hum or
noise
Remote
control doesn't
work
The disc does
not play.
The CD door
will not open.

Specifications

Power consumption:
AC power requirements:
Specifications and external appearance are
subject to change without advance notice due to
continuous product improvement.
www.insignia-products.com
Solution
Make sure that the power cord is
connected to a power outlet.
• Make sure that the RCA cable is
connected securely.
• Make sure that you've selected the
correct equipment on the system.
• The system is in pause mode. Press
the PLAY button to return to normal
play mode.
• Fast forward or fast reverse is active.
Press the PLAY button to return to
normal play mode.
• Check the volume setting.
• Adjust the speaker volume.
• The player is too hot. Shut off the
player for 30 minutes to cool down.
• Make sure that the connecting cords
are not too close to transformer or
motor, and at least 10 feet (3 meters)
away from a TV set or fluorescent
light.
• Make sure that the plugs and jacks
are not dirty. Wipe them with a cloth,
slightly moistened with alcohol.
• Clean the disc.
• Vibrations from the speakers may be
affecting the CD player.
• Remove any obstacles between the
remote and the player.
• Use the remote closer to the player.
• Point the remote at the remote
sensor window on the player.
• Replace the battery in the remote
with new one.
• There is no disc in the player.
• Insert the disc correctly with the
playback side facing down (label side
up) on the disc tray.
• Clean the disc.
• The player is in pause mode.
• Condensation may have formed
inside the player due to a sudden
change in temperature. Wait about
an hour for it to clear and try again.
Reset the player —press the
(Standby/on) button to turn the player off,
wait for a few seconds, then press the
(Standby/on) button to turn the
player on.
10W
100V 50/60Hz (Japan)
110V/120 - 220/240 50/60Hz (Other
countries)
120V 60Hz (USA and Canada)
220V 50Hz (Hong Kong and China)
230-240V 50Hz (Europe)
240V 50Hz (Australia)
7