Applicable Controls; Wiring Diagram - Toshiba RAV-SM307KRTP-E Installation Manual

Terminal block for wired
remote controller /
Central control
Earth screw
Cord clamp
Terminal
Terminal block for
cover
Indoor / Outdoor
connecting
Screw
Screw
Terminal block
for Indoor / Outdoor
connecting wiring
Earth screw
Wired remote
controller wire
Cord clamp
◆

Wiring diagram

Terminal block for
Terminal block
remote controller
wiring of Indoor unit
A
A
B
B
Remote controller wire
(locally procured)
23-EN
11
Applicable
controls
REQUIREMENT
•
When this air conditioner is used for the fi rst time, it
takes approx. 5 minutes until the remote controller
becomes available after power-on. This is normal.
<When power is turned on for the fi rst time
after installation>
It takes approx. 5 to 10 minutes until the remote
controller becomes available.
Approx. 5 minutes
"SETTING" "SETTING"
Power on
flashes goes out
<When power is turned on for the second (or
later) time>
It takes approx. 1 minute until the remote
controller becomes available.
Approx. 1 minutes
"SETTING" "SETTING"
Power on
flashes goes out
•
Normal settings were made as factory default.
Change the indoor unit settings as required.
• Use the wired remote controller to change the
settings.
* The settings cannot be changed using the
wireless remote controller, simple wired remote
controller, or remote-controller-less system
(for central remote controller only). Therefore,
install the wired remote controller to change the
settings.
Remote
controller
unit
■ Basic procedure for changing
settings
Change the settings while the air conditioner is not
working.
(Stop the air conditioner before making settings.)
CAUTION
Set only the CODE No. shown in the following table:
Do NOT set any other CODE No.
If a CODE No. not listed is set, it may not be possible
to operate the air conditioner or other trouble with the
product may result.
* The displays appearing during the setting process
Remote
differ from the ones for previous remote controllers
controller is
(AMT31E). (there are more CODE No.)
available
4
Remote
controller is
6
available
1
1
Push button and TEMP.
simultaneously for 4 seconds or more.
After a while, the display flashes as shown in the
figure.
Confirm that the CODE No. is [01].
• If the CODE No. is not [01], push
to erase the display content, and repeat the
procedure from the beginning.
(No operation of the remote controller is
accepted for a while after
(* Display content varies with
the indoor unit model.)
– 12 –
2
Each time
unit numbers in the control group change
cyclically. Select the indoor unit to change
settings for.
The fan of the selected unit runs. The indoor unit
can be confirmed for which to change settings.
3
Specify CODE No. [
buttons.
4
Select SET DATA [
buttons.
5
Push
from flashing to lit, the setup is completed.
•
To change settings of another indoor unit,
1
repeat from Procedure
•
3 To change other settings of the selected indoor
unit, repeat from Procedure
Use
To make settings after
repeat from Procedure
6
When settings have been completed, push
button to determine the settings.
5 2
When
and then the display content disappears and the
air conditioner enters the normal stop mode.
button
(While "SETTING" is flashing, no operation of the
remote controller is accepted.)
button
button is pushed.)
button is pushed, indoor
] with TEMP. /
] with TIME /
button. When the display changes
2
.
3
.
button to clear the settings.
button was pushed,
2
.
button is pushed, "SETTING" flashes
24-EN