Intermec PM4i Installation Instructions
Power supply unit
Hide thumbs
Also See for PM4i:
- User manual (186 pages) ,
- Installation instructions manual (40 pages) ,
- Safety instructions (24 pages)
Advertisement
Quick Links
PM 4i
Power Supply Unit Installation Instructions
Use these installation instructions to replace the power supply unit (PSU) on
the PM4i printer. The PSU kit ships with these items:
•
Power supply unit (P/N 1-971131-003)
•
This installation instruction sheet
To install the power supply unit, you need:
•
T20 Torx screwdriver
This installation procedure must only be performed by an
authorized Intermec service technician. Intermec assumes no
responsibility for personal injury or damage to the
equipment if the installation is performed by an
unauthorized person.
The electrical components in the printer are susceptible to
damage from electrostatic discharge (ESD). You must
follow standard ESD guidelines to avoid damaging the
equipment you are servicing.
To install the power supply unit
1
Turn off the printer power and remove the power cord.
2
Lay the printer on its left cover (the electronics and front cover).
Advertisement
Related Manuals for Intermec PM4i
Summary of Contents for Intermec PM4i
- Page 1 PM 4i Power Supply Unit Installation Instructions Use these installation instructions to replace the power supply unit (PSU) on the PM4i printer. The PSU kit ships with these items: • Power supply unit (P/N 1-971131-003) • This installation instruction sheet To install the power supply unit, you need: •...
- Page 2 Remove the four T20 Torx screws from the bottom of the printer and then set the printer back upright. Screw (4 places) 4 Open the media cover and remove the four T20 Torx screws that attach the electronics and front cover to the printer. Screw (4 places)
- Page 3 Lift the electronics and front cover door away from the printer and carefully disconnect the console cable from the CPU board. 6 Disconnect all of the cables from the CPU board. Remove the four T20 Torx screws and the standoff that attach the CPU board to the power supply unit and lift it away from the printer.
- Page 4 Worldwide Headquarters 6001 36th Avenue West Everett, Washington 98203 U.S.A. tel 425.348.2600 PM4i Power Supply Unit Installation Instructions fax 425.355.9551 *931-067-001* www.intermec.com © 2009 Intermec Technologies P/N 931-067-001 Corporation. All rights reserved.