Panasonic PT-RZ670 Operating Instructions Manual page 55

Chapter 3 Basic Operations — Switching on/off the projector
f When the cursor is moved from [CALIBRATION TIME] using as, [CALIBRATION TIME] is fixed.
f Brightness and color are measured at the specified time. Iris is fixed to open during measurement.
f When not specifying the time, press as to select [CALIBRATION TIME] (the state where the time is not blinking), and press the
<DEFAULT> button.
13) Press as to select [CALIBRATION MESSAGE].
14) Press qw to switch the item.
f The items will switch each time you press the button.
[ON]
[OFF]
15) Press the <ENTER> button to proceed to the initial setting.
Interrelation of luminance and runtime
You can use the projector with desired brightness and duration of use by combining the settings of [CONSTANT MODE] in [MAX LIGHT
OUTPUT LEVEL], [LIGHT OUTPUT], and [BRIGHTNESS CONTROL SETUP].
Interrelation of luminance and runtime is as follows. Make the initial setting (operation setting) depending on your desired duration of use and
brightness of the projected image.
Values of the luminance and runtime are rough estimations.
r To set the projector based on the duration of use
Duration of use
[MAX LIGHT
(hour)
OUTPUT LEVEL]
20 000 100.0
24 000 100.0
27 000
100.0
31 000 100.0
35 000
40 000
r To set the projector based on luminance
[MAX LIGHT
Luminance (lm)
OUTPUT LEVEL]
5 500 100.0
5 000 100.0
4 500 100.0
4 000 100.0
3 500 100.0
3 000 100.0
2 500 100.0
2 000
Note
f Under influence of characteristics of each light source, conditions of use, installation environment, etc., the runtime may be shorter than the
estimation.
f The duration of use is referred to as the runtime when you use the projector successively. The duration of use is an estimated duration and
is not the warranty period.
Displays the message during calibration.
Does not display the message during calibration.
When [CONSTANT MODE] is set to [OFF]
[LIGHT OUTPUT]
(%)
(%)
100.0
80.0
67.0
46.0
― ―
― ―
When [CONSTANT MODE] is set to [OFF]
[LIGHT OUTPUT]
(%)
(%)
85.0
77.0
69.0
62.0
54.0
46.0
38.0
― ―
When [CONSTANT MODE] is set to [AUTO] or [PC]
[MAX LIGHT
Luminance (lm) OUTPUT LEVEL]
(%)
6 500 100.0
5 200 100.0
4 400 74.0
3 000 71.0
― 69.0
― 66.0
When [CONSTANT MODE] is set to [AUTO] or [PC]
[MAX LIGHT
Runtime (hour) OUTPUT LEVEL]
(%)
23 000 100.0
25 000 100.0
26 500 100.0
28 000 100.0
29 500 100.0
31 000 100.0
33 000 72.0
― 68.0
[LIGHT OUTPUT]
Luminance (lm)
(%)
54.0 3 500
46.0 3 000
43.0 2 800
37.0 2 400
32.0 2 100
28.0 1 800
[LIGHT OUTPUT]
Runtime (hour)
(%)
85.0 4 000
77.0 7 500
69.0 11 000
62.0 15 000
54.0 20 000
46.0 24 000
38.0 30 000
31.0 36 500
ENGLISH - 55