Radio Shack Chronomatic-300 User Manual page 5

2. Plug the cord's other end into the smaller of the two modular jacks on
the phone's base.
3. Connect one end of the supplied flat modular cord into the other
modular jack on the phone's base.
4. Plug the other end of the flat modular cord into the telephone line's
modular jack.
NOTE: If necessary, reconnect the AC power cord to a standard AC
outlet.
5. Insert the two supplied detachable legs into the stand slots on the
phone's base.
MOUNTING YOUR TELEPHONE DIRECTLY ON A WALL
Follow these steps to mount your phone directly on a wall.
NOTE: The location you select to mount the phone might affect AM radio
reception.
while the radio is turned on and tuned to an AM station.
1. Drill two 1/8-inch holes 3 15/16-inches (100 mm) apart.
screws into the holes until the heads extend only about 5/64-inch (2
mm) from the wall.
NOTE: To make it easier to connect the telephone cords, you might want
to temporarily disconnect the AC power cord from the standard AC
outlet.
2. Connect one end of the flat modular cord into the larger of the two
modular jacks on the phone's base.
3. Thread the cord downward and into the groove on the right of the back
of the phone's base.
4. Plug the other end of the modular cord into the telephone line's
modular jack.
5. Align the keyhole slots with the mounting screws, then push the phone
onto the screws and slide it downward to secure it in place.
6. Plug one end of the supplied coiled cord into the jack on the
telephone's handset.
To get the best AM radio reception, select the location
Thread two