Lighting The Burners; For Correct Use Of The Hob - EF HB-AG290VGB-A User Manual

Lighting the burners

To obtain a flame more easily, light the burner before placing a cooking
utensil on the pan stand
To light a burner, proceed as follow: for Version with lighting integrated in
the
control knob push the knob of the burner fully down and turn it
anticlockwise
to the "maximum flow" setting symbol, or press the button if the appliance
has individual lighting.
After lighting the flame, keep the knob pressed for about 10 seconds: this
●
time is necessary to heat up the "thermocouple"(Fig.1-C) and activate the
safety valve, which would otherwise cut off the gas flow.
Then check that the flame is even and turn the control knob to adjust the flame
as required
In the instance of a power cut, place a flame near the burner and proceed as
already described.
If the flame does not light after a few attempts, check that the "burner cap" and
"flame cap" are correctly positioned.
To turn off the flame, turn the control knob clockwise to the
Before removing pans from the burners, always lower or turn off the
flame.

For correct use of the hob

For lower gas consumption and better efficiency. Use only flat-bottomed pans of
dimensions suitable for the burners, as shown in the table below. Also, as soon as a
liquid comes to the boil take care to turn the flame down to a level that will just keep
it boiling.
Burner
Large(rapid)
Medium(semi-rapid)
Small(Auxiliary)
Triple Flame
During cooking processes involving fats or oils, watch your foods
carefully
because these substances may catch fire if brought to high temperatures.
minimum diameter
180mm
120mm
80mm
220mm
● symbol.
maximum diameter
220mm
200mm
160mm
260mm
5