Others; Troubleshooting - Panasonic HC-X1000 Owner's Manual

Others

Troubleshooting

∫ It is not a malfunction in following cases
The lens, the viewfinder or
LCD monitor fog up.
Object seems to be warped. ≥ Object seems to be warped slightly when the object moves
Problem
This unit cannot be turned
on.
This unit does not stay on
long enough.
Battery runs down quickly.
This unit cannot be
operated though it is
turned on.
This unit does not operate
normally.
The unit arbitrarily stops
recording.
Color or brightness of the
image changes, or you
may see horizontal bars in
the image.
The LCD monitor flickers
indoors.
Please refer to "Owner's Manual (PDF format)" for details.
42
SQT0477 (ENG)
≥ This is due to condensation. It is not a malfunction. Please
refer to page 9.
across the image very fast, but this is because the unit is using
MOS for the image sensor. This is not a malfunction.
≥ Charge the battery again to ensure it is sufficiently charged.
(l 20)
≥ In cold places, the battery using time becomes shorter.
≥ The battery has a limited life. If the operating time is still too
short even after the battery is fully charged, the battery has
worn out and needs to be replaced.
≥ Remove the battery or AC adaptor, wait about 1 minute and
then reconnect the battery or AC adaptor. Then about
1 minute later, turn on the unit again. (Conducting the above
operation while the media is being accessed may damage the
data on the media.)
≥ If normal operation is still not restored, detach the power
connected, and consult the dealer who you purchased this
unit from.
≥ Use an SD card that can be used for motion picture recording.
(l 23)
≥ The recordable time may have shortened due to the
deterioration of the data writing speed or repeated recording
and deletion. Using the unit, format the SD card. (l 29)
≥ Color or brightness of the image may change, or you may see
horizontal bars in the image when the object is recorded
under fluorescent light, mercury light or sodium light, etc., but
this is not a malfunction.
≥ Record images in Intelligent Auto Mode or adjust the shutter
speed to 1/50, 1/60 or 1/100.
≥ Adjust the Synchro Scan shutter speed.
Check points