Makita CC300D Instruction Manual page 8

1
2
3
4
012357
To install the diamond wheel, follow the removal
procedure in reverse. Always install the diamond wheel
so that the arrow on the diamond wheel points in the
same direction as the arrow on the diamond wheel case.
BE SURE TO TIGHTEN THE HEX BOLT SECURELY.
1
2
012438
NOTE:
If a inner flange is removed by chance, install the
•
inner flange so that its protrusion (bigger side)
faces inside as shown in the figure.
Hex wrench storage
012358
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
Installing water supply
3
012365
1. Inner flange
2. Diamond wheel
3. Outer flange
4. Hex bolt
1. Hex bolt
4
2. Outer flange
3. Diamond wheel
4. Inner flange
5. Protrusion
(bigger side)
5
3
1. Hex wrench
1
2
1. Tank holder
2. ScrewA
1
3. Notch
4. Motor housing
4
Loosen the screw A. Slide the tank holder all the way
over the motor housing. Position the notch of the tank
holder positions just below the screw head as illustrated.
Then tighten the screw A.
1
3
012366
Attach the tank on the tank holder so that the tank holder
fits between the step and dots. Connect the cap on the
tube end to the mouth of the tank. Turn the tank
clockwise. Then tighten the screw B.
Water supply
1
012367
1
2
3
012368
Be sure that the water supply cock is closed before filling
the tank with water. Open the cap on the tank and fill the
water. Recap the tank.
CAUTION:
When filling the tank with water, be careful not to let
•
the tool get wet.
8
1. ScrewB
2. Tank
3. Tube
2
1. Cap
2
2. Open
1. Water supply
cock
2. Close
3. Open