Quasimidi Rave-O-Lution 309 Owner's Manual page 39

Installationguide
8.) In this step you have to fix the 4 jacks of the I/O-Board with the included 4 plastic nuts. Please
attach the nuts with your fingers only. Don't use a plier. Otherwise the nuts and jacks may be
damaged.
9.) Put the Frontpanel into
installation position and lean it back
carefully.
Attach the cable of the volume-
knob board to its connector.
Ensure the correct position of the
cable (see step no. 2).
10.) Check again the correct fitting of all cables. Now put the Frontpanel onto the body. Take care
that there is no cable stucked between the Frontpanel and the body. Fix the Frontpanel crosswise
with the 6 screws.
Attention: Don't tighten the screws too hard! The screws and the body of the 309 could be
damaged!
8
7.) Now the attached cable on the
I/O-Board must be connected with
the Mainboard of the 309. There is
just one way to connect the cable
with the "AUDIOEXP" named
connector on the Mainboard
because it is already pre-bent.