Quasimidi Rave-O-Lution 309 Owner's Manual page 36

e.) Using the IC tool, remove the chip.
To remove the IC from the socket,
place the IC tool at the both ends of the
IC. Be careful to place it directly under
the IC, not under the socket. Pull
carefully, alternating from the left and
right sides, and remove the chip. Once
removed, place the old chip on the
backside of the foam material.
Notch
Don't forget to "Ground" yourself now.
First, press the IC into the socket gently, then double-check the polarity and the positions of all
pins a second time. If everything is OK, carefully press the IC into the socket until fully seated.
f.) Screw the small bottom plate onto the 309 body.
QM-309
O.S
V 2.0
Notch
Installationguide
EPROM with Operating System
Insert the new IC into the socket.
Pay attention to the polarity (notch!)
and make sure that all the IC's pins
fit the socket.
5