Table of Contents
Advertisement
The image appears
distorted
The image appears
too 'washed out', or
the darkest areas of
the image appear too
bright
Picture is not clear, or
there is no image
display when viewing
PC input
Remote control does
not function properly
• Ensure the display's aspect ratio is correctly set to suit the
image source.
• Try a different input source to confirm if the symptom is
still present or whether the source is at fault.
• Lower the
Contrast
• The output resolution of the source device (e.g. DVD
player) may be set too high. Reduce its output resolution.
• The video signal has not been terminated properly
somewhere in the external equipment. Check the
connection and try again.
• Reduce the brightness level until the black areas of the
picture appear as black.
• The input source device (e.g. DVD player) brightness
level may be set too high. Reduce its brightness level.
• Check the connection of cables.
• The PC video output resolution is not supported by the
display and cannot be displayed. Refer to
(D-Sub/DVI) input signal resolutions" on page 30
"Setting up appropriate output resolution on PC" on
page 31
to select a compatible output resolution on the
PC and try again.
• The PC output resolution is set too high. 1360 × 768 @
60Hz is the highest acceptable PC timing.
• If the displayed image appears to be shimmering and
unclear, use the Auto Adjust function in the
menu to let the display adjust the picture settings
automatically.
• Check for incorrect battery orientation.
• Check for dead batteries
• Check your distance and angle from the display.
• Check whether remote control is properly being pointed
at the display's remote control sensor window.
• Check for any obstacle between the remote control and
the remote control sensor window.
• Check that the remote control sensor window is not
under strong fluorescent lighting. or in direct sunlight.
• Check for any devices (PC or personal digital assistant,
PDA) nearby that transmit infrared signals which may
cause interference to signal transmission between the
remote control and the display. Turn off the infrared
function of these devices.
setting.
"Supported PC
and
Picture
Reference
33
Advertisement
Table of Contents
