Home Canning - Jenn-Air SU146 User And Care Manual

Using Cooktop
Cartridges
Cooktop cartridges, either conventional coil, glass-ceramic, solid element or induction,
can be installed on either side of the range.
To Install Cartridges
1. If the grill element, grill-rocks or grates are in place, remove before installing
a cooktop cartridge. Clean grill basin of any grease accumulation. (See page 15
for cleaning recommendations.)
2. To install any of the optional cooktop cartridges, first be sure control knobs are
turned OFF. Position the cartridge terminal plug towards the terminal receptacle.
This receptacle is located at the front of the left side and at the back of the right side
of the range.
3. Slide the cartridge towards the receptacle until the cartridge terminal plug is
completely engaged.
4. Lower the opposite end of the cartridge into the range top until it is flush with the
surface. Your range is now ready to use.
To Remove Cartridges
1. Control knobs must be in the OFF position and the cartridge should be cool.
2. Lift up on the "tab" located on the cartridge until top of cartridge clears the open ing
on the range top by about 2 inches. Lifting the cartridge too high while still
engaged in the receptacle could damage the terminal plug.
3. To disengage terminal, hold cartridge by the sides and slide away from the
terminal receptacle. Lift out when fully unplugged.
4. A storage tray, Model A350, is availalbe and can be used for storing a cartridge
(except the induction cartridge).
5. Do not stack cartridges where they may fall or be damaged. Never store other
materials on top of the glass-ceramic cartridges since this could damage or mar
the surface.
Home Canning
Canning should be done on the conventional coil or induction cartridge only. Canning
element accessory, Model A145, makes it possible to use large canners with
conventional coil cartridge.
10