Voice Menu; Audio Sources And Priorities; Resetting Your Headset; Getting Started - SCHUBERTH SRC-System User Manual

4.5 VOICE MENU

The Voice Menu is available in several languages.
1. P ress and hold the Channel "A" button and Channel "B" button simultaneously
for 3 seconds while on standby.
2. A fter entering the menu, follow the voice instructions in English or choose your
preferred language

4.6 AUDIO SOURCES AND PRIORITIES

The different audio sources connected to the SRC-System™ are prioritized as
shown below, i.e. the higher priority source will always override and interrupt
the lower one.
For example, incoming phone calls will interrupt ongoing Intercom calls, while
incoming intercom calls will interrupt the audio from the built-in FM Radio etc.
Higher Priority
1. Mobile Phone audio or GPS instructions*

2. Intercom / Click-to-Link®
3. A2DP (Stereo Bluetooth) audio
4. FM Radio (Built-in)
5. AUX (for corded connection i.e. Music Players)
Lower Priority

4.7 RESETTING YOUR HEADSET

If your SRC-System™ fails to respond despite repeated attempts, you can reset
your headset by charging it. After approximately 10 seconds, remove the headset
from the charger and turn it on again. It should now respond as expected.
15.
26
*GPS instructions from Smartphone GPS Apps are
prioritized like A2DP audio
5. GETTING STARTED

5.1 REMOVING THE EXISTING ACOUSTIC COLLAR

First, remove the existing Acoustic Collar from your helmet as follows:
Pull out and remove the Acoustic Collar from the front at its bent center.

5.2 CONNECTING THE ANTENNA CABLE

Your SRC-System™ has an antenna cable which must be connected to the built-
in antenna cable connector in the Schuberth helmet.
NOTE: Make sure to close the cover of the USB
connector, and then tuck it away into
the USB connector pocket.
1. Pull out the antenna connector (marked with a red tag) which is tucked
inside the back rim of the helmet.
Antenna tag visible
Antenna connector
pulled out