Configuring Phones - Gigaset T300 PRO Administrator's Manual

Configuring phones

Instructions on automatically detecting and configuring phones via the network can be
found in the Initial configuration
£
Page 8).
Manually configuring phones
Softphones and hardware phones that cannot be configured automatically can be set up
manually.
¤
Using the Manually button, open the dialogue for configuring additional phones.
¤
Select the type of phone from the Telephone Type dropdown list.
This dropdown list contains all standard phones currently supported by Gigaset T300
PRO / Gigaset T500 PRO. If a device or softphone is not listed, you can either:
– Select "Standard SIP", which contains the basic function settings.
– Create your own configuration for this type of device (see
£
types
¤
Enter a name and password in the Telephone name and Password fields for the end
device. These two entries, in conjunction with the server (IP) address, form the SIP
account.
Please note
The field corresponding to Telephone name has different designations in the config-
uration interface on the various phone types (clients). Examples include: User name,
authorisation name/authentication name.
For some clients, the Telephone name must be entered in two separate fields, e.g., in
user name und authorisation name.
¤
Click on Save to complete the manual configuration of a new phone.
¤
Assign the phone to a user. This will then show the phone's state as active.
Important
For softphones and manually configured end devices, it is also necessary to enter the
SIP account (user name, password, server IP address) in the settings of the respective
phone and to restart the device.
chapter (see
Page 27).
Step 1: Configuring the phone
Defining new device
Phones
25