Drill Setup - KOBE DMM3050 Operator's Manual

KBE-268-4220K_Instructions.qxd 29/09/2011
KOBE
I N D U S T R I A L
POWER TOOLS
Caution! This Drill is heavy, take care when unpacking.
Remove the Drill, together with the accessories supplied,
from the packaging. Check carefully to ensure that the Drill
is in good condition and account for all the items listed on
page 5 of this manual. Also make sure that all the parts
are complete. If any parts are found to be missing or
damaged, the Drill and its accessories should be returned
together in their original packaging to the retailer. Do not
throw the packaging away, keep it safe throughout the
guarantee period, then recycle if possible, otherwise
dispose of it by the proper means. Do not let children play
with empty plastic bags due to the risk of suffocation.
The Drill comes ready assembled but it is advisable to
check mounting screws to make sure they are tight before
use.
FITTING THE CHUCK
If not already attached, screw the chuck onto the thread on
the Weldon adaptor. Loosen the grub screws in the drill
shank then insert the Weldon adaptor into the drill spindle
as shown in Fig. 2. Tighten both Grub screws with the
Hexagon key supplied. Fig.3
FITTING THE GUARD Position the white nylon guard
over the end of the magnet base as shown and secure in
place with the hexagon grub screws and wing nuts as
shown in Fig. 4
Fig.4
6
12:36 Page 6
ASSEMBLY
Fig.2
Fig.3
KOBE

DRILL SETUP

I N D U S T R I A L
POWER TOOLS
SECURING THE DRILL (Fig.5)
When working horizontally or overhead, the Drill should
always be secured using a safety strop or the chain
supplied. The safety securing chain has a spring carabine
hook to facilitate anchoring the drill either direct to the
steelwork or to a webbing strop.
Remember - the drill must only be used on steel with a
thickness of 6mm or above.
COOLANT SUPPLY
The Drill comes complete with a gravity feed coolant bottle.
The pipe fits directly into the fitting on the side of the
Weldon Adaptor a shown in Fig. 6. The bottle has a wire
hook around the neck for attaching to the top of the slide as
shown in Fig.7 or suspended from the securing chain as
shown in Fig.7a when the drill is being used in the
horizontal plane on steelwork as it needs to be kept above
the working position of the drill.
Fig.7
Fig.5
Fig.7a
Fig.6
7