Safety Instruction - KOBE DMM3050 Operator's Manual

KBE-268-4220K_Instructions.qxd 29/09/2011
KOBE
I N D U S T R I A L
POWER TOOLS
10
12:36 Page 3
ITEMS FROM
KOBE

SAFETY INSTRUCTION

THE KOBE RANGE
I N D U S T R I A L
POWER TOOLS
PERSONAL PROTECTION
Always wear approved eye protection during operation. Use safety glasses or goggles which conform to
BSEN136 or CE equivalent that provide protection from the front and side. The operator of the Mag Drill
is responsible for following accepted eye, face, respiratory, hearing and body protection.
Always ensure that all long hair and loose clothing, ties, scarves, jewellery, etc., are secured or removed.
Always consult a doctor if numbness, tingling, pain or whitening of the skin occurs. Repetitive work
motions, awkward positions and exposure to vibration can cause "Repetitive Strain Injuries".
SPECIFIC OPERATING HAZARDS
The pillar drill must only be used on metal plate with a minimum thicknes of 6mm.
Always ensure the electric cable is not damaged before connecting the Mag Drill to the electricity
supply.
Always use recommended attachments or parts and make sure that they are kept sharp and fitted
correctly, that all the securing bolts are tight and the guard is fitted and operating correctly and that the
chuck key and any other adjustment tools have been removed.
When drilling use the correct cutting lubricant/coolant for the material being drilled. Use only sufficient
to prevent the drill from overheating and make sure that it is kept well away from electrical components.
Never use water as a coolant.
When drilling long lengths ensure that there is adequate support at both ends of the material.
Never use the machine without the safety guard in position and operating correctly.
Always secure the workpiece with suitable clamps.
Warning: Be aware that swarf can be very sharp, hot and can fly off the rotating drill. When handling swarf
always wear suitable gloves. Swarf should not be disposed of with domestic waste, it should be disposed
of at a recycling centre.
Never leave the mag drill connected to the electric supply when unattended.
Always switch off using the on/off switch when not in use.
Never use the Drill without the guard attached.
Never deface the rating plate on the drill.
Never make any alterations to the Drill and only use it for the task for which it has been designed.
..... and
many more!
3 3